Taking a Break on a Snowy Day…By Splitting Firewood

Posted on Wednesday, April 24, 2013 by Scott

b2ap3_thumbnail_20130420_160233_20130424-224027_1.jpg
     So life on the farm changes in accordance to the weather, which I’m sure you agree, is quite a bit, quite often. So being late April, it’s time to prepare for planting. However, waking up to snow, most of those preparations must wait! So what did we do? Got our corn seed delivered, as scheduled, but since we couldn’t get on the snow-covered land…we went with our ever present plan B: Firewood. 

 

    In order to keep our forest floor clean of large debris, it’s essential we remove any dead trees that are prone to fall during a storm. On top of that, there is bound to be some wood from trees that we miss, that does end up on the ground! Other than that, the forest needs to be kept at a certain density in order to promote even and full growth of all the trees. If the seedlings grow too close together, they choke each other out, and don’t reach their full potential. By removing some trees, maintaining a certian density, it allows the ones around them to grow big and healthy. From collecting all of this wood, we cut it into 12” and 16” inch lengths to prepare for splitting. By splitting it into smaller pieces, piling it under shelters which have air access from the fronts and the backs, the wood can dry enough to be burnt as fuel for heating a house. The drying process with our shelters takes anywhere from 8-12 months at most, dependent upon the type of wood. With the rising oil, fuel, and natural gas prices, the demand for firewood has been increasing in recent years. Typically, customers have told us that they are relying a little more each year on wood for their fireplace in their house, in order to rely less on natural gas, offsetting their heating bills to some degree.

 

     Wood isn’t always in the best condition, however. If it’s any that we collected that was fallen down, it may have started to rot a bit, which customers don’t like. Since this still produces copious amounts of heat when dried and burnt, we cut it into four foot lengths, split it, and dry this for a year. After a year, it’s ready to use in our outdoor wood furnace. This system is something I was unaware of until my dad invested in it, and accomplishes some pretty important things for our farm.
More pictures of cutting/splitting/piling to come, along with a post about our furnace, and its’ capabilities!

Leave a Reply

Your email address will not be published. Required fields are marked *