It is a job that needs to be done at least twice a day, every day, so it has to be done well. (some farms even do it three times a day) Here are the steps we go through to milk our cows.
Step one: Get your dip to clean each of the four teats & then get a paper towel.
This box takes a spin around the barn every time we milk, holding the clean paper towels. Using the dipper hanging from the side, we coat the teat in a disinfecting iodine solution. After waiting 15 or 30 seconds we wipe the solution clean.
Step Two: Check the milk.
Before we place the milking unit on, we want to check to make sure the milk quality is exactly as it was 12 hours ago. If we ever see something abnormal, the cow is milked into a bucket until we figure out what might be wrong. To find abnormal milk isn’t common & not the case here – so on goes the milker!
Step 3: Milkers On.
With the teats clean and the milk quality good, this milking unit is put on. A soft suction keeps it from falling off, while it gently squeezes the teats making a similar action to what you & I would have to do if we were milking her by hand. (Start at the top of the teat near the udder, gently squeeze, and pull down to the bottom of the teat)
Step 4: Wait for her to finish & then give a final dip.
Each of our milking units record how much milk flows through, and at what rate. That way, when the cow is finished it can pull the milking unit off automatically so as to not over milk the cow. When this is finished, we come along with another iodine based solution that will coat each teat again to protect against bacteria for the next 12 hours before we start the job all over again!
All of this needs to be done with calmly & patiently as cows have the ability to hold their milk. If they aren’t comfortable – they won’t give their milk. Luckily, they are quite happy with our twice-daily routine and milk flows freely! Celine chews her cud while she is milked. (an action required by cows to digest their food – something they do several hours a day)